DROK DC motor driver input voltage range is DC 6.5V-27V, can be input DC 12V or 24V, rated output current of each port is 7A, total output power is 160W.
STRONG DRIVE: the motor controller board adopts dual H bridge, can drive two DC motors at the same time.
FORWARD and REVSERSELY ROTATE: the IN1, IN2/IN3, IN4 port can control forward or reverse motor rotation.
PWM SPEED CONTROL: enable signal terminal (ENA) input PWM can regulate speed, PWM frequency range 0-10KHZ.
UNDER VOLTAGE PROTECTION: the motor driver module is with under voltage protection to prevent instantaneous large current from damaging the module.
Teyleten Robot TB6612FNG Dual DC Stepper Motor Driver Module 1.2A Peak 3.2A Better Than L298N(Pack of 3)
KWD 4.500
Protactor 2 Pole 40 AMP Heavy Duty AC Contactor Replaces Virtually All Residential 2 Pole Models
KWD 9
MC-33C Normally Closed Recessed Window Door Contact Sensor Alarm Magnetic Reed Switch 2 Sets
KWD 3.500
TWTADE 3 Pcs Latching Toggle Rocker Switches 4 Pin 2 Position ON/Off DPST Heavy Duty 16A 250VAC Spade Terminal Metal Boat Switch with Waterproof Boot Cap + 6.3mm Terminal Wires TEN-1221MZX-B201
KWD 6
